Google+ Shipped by EXPRESS,Geeetech Unassembled Crazyflie Nano-quad tiny Drone Quadcopter Kit 10-DOF with Crazyradio 2.4Ghz nRF24LU1+USB radio dongle with antenna - Drones HomeDrones Home

Shipped by EXPRESS,Geeetech Unassembled Crazyflie Nano-quad tiny Drone Quadcopter Kit 10-DOF with Crazyradio 2.4Ghz nRF24LU1+USB radio dongle with antenna

April 9, 2015 - Comment

Please note: The list is UNASSEMBLED,you need to build it by yourself when you receive it. The Crazyflie is a tiny quadcopter often referred to as a nano-quad, built using the PCB itself as the frame. Developed solely by open source tools and designed with development in mind.A Crazyflie Nano Quadcopter include a crazyflie and

Buy Now! $200.00Amazon.com Price
(as of December 16, 2017 16:26 UTC - Details)

Please note: The list is UNASSEMBLED,you need to build it by yourself when you receive it.

The Crazyflie is a tiny quadcopter often referred to as a nano-quad, built using the PCB itself as the frame. Developed solely by open source tools and designed with development in mind.A Crazyflie Nano Quadcopter include a crazyflie and a crazyradio.

Basic concepts:

The Crazyflie is controlled from a computer using an input device such as a game controller (PS3 or Xbox 360). A USB radio dongle is used to send control data from the controller/computer to the quadcopter.

The primary stage

Packet

&& Crazyflie control board

&& 5 x motor mounts (one as spare)

&& 5 x coreless motors (one as spare)

&& 5 x CW propellers

&& 5 x CCW propellers

&& 1 LiPo batter

&& Crazyradio 2.4Ghz nRF24LU1+ USB radio dongle with antenna

Tools you need:

&& Soldering iron and solder

&& Scissors

&& Tweezers and a clamp or third-hand can come in handy

Check the electronics

Before you go ahead and assemble the Crazyflie check the Crazyflie control board and the Crazyradio electronics:

Attach a powered micro-USB cable to the Crazyflie control board. It should power up and blink 5 times with the green LED. After that the green LED should be fully on and the red LED should blink.

More information, please check our page:http://www.geeetech.com/crazyflie.html

Product Features

  • Small and lightweight, around 30g and about 90mm motor to motor,3-axis high-performance MEMs gyros with 3-axis accelerometer: Invensense MPU-6050
  • Light time up to 7 minutes with standard 180mAh Li-Po battery,Powerful 32 bit MCU: STM32F103CB @ 72 MHz (128kb flash, 20kb RAM)
  • Standard micro-USB connector for charging which takes ~20min for the stock 180mAh Li-Po battery
  • On-board low-energy radio@1mW based on the nRF24L01+ chip. Up to 80m range (environment dependent) when using the Crazyradio USB dongle,Radio bootloader which enables wireless update of the firmware
  • Available footprints to manually solder magnetometer HMC5883L/HMC5983 or/and barometer MS5611 (Mounted on the 10-DOF version),Expansion header 2×10 pins 1.27mm (0.05″) pitch including power, I2C/UART, SPI/ADC. Header also contains ARM Cortex 10-pin JTAG (header not included)

Comments

Leave a Reply