Google+ DJI Phantom 2 Vision+ Plus V3.0 RC Quadcopter Drone w/FPV HD Cam Firm W/upgraded - Drones HomeDrones Home

DJI Phantom 2 Vision+ Plus V3.0 RC Quadcopter Drone w/FPV HD Cam Firm W/upgraded

June 22, 2015 - Comment

This is an open box item never flown but inspected for operation. I, cut the seal myself and removed the 4gb card and replaced it with a 16gb Sandisk card. I also added a set of Prop Guards for the new pilots peace of mind. The box contains all items in new condition. All 8

This is an open box item never flown but inspected for operation. I, cut the seal myself and removed the 4gb card and replaced it with a 16gb Sandisk card. I also added a set of Prop Guards for the new pilots peace of mind. The box contains all items in new condition. All 8 props unused No Marks at all except for my prints. I updated the Phantoms firmware to ver 3.8 and the controllers firmware to 1.02.31 5.8ghz I left the settings in the Phantom Vision app set to Phantom mode. But Naza-M mode for the experienced pilot is available after he becomes experienced in the advanced operation of this quad. I know every body wants to just take off flying but my subjection is to set up this quad with your the Iphone or IPad app or Android App to get your video working and then remove the camera and learn to fly this quad by line of eye sight only. There is no need to carry around a $600.00 dollar camera when learning to fly. You will thank me if you crash. The camera is very easy to remove. First remove the battery. Then just push in on the plastic grip washers until the lock pins expand over main pin shaft. The grips will open fully then align two of the four grips left and right at 180deg and wiggle left and right to expand grips just a little more then rotate to the other 2 grips and do the same. Then fast push up on pointed end of the main shaft pin and pull the grip washer strait off before the grips spring back to their original locking position. If the grips spring back repeat or pry the grip pins out a little to clear the locking grove. That it. remove the ribbon cable connectors by prying strait up the small cable has a locking tab that needs to be pushed in and then pried up. There are Youtube vid’s on removing and installing the vibration dampeners. Also do not run these 2312 motors with out props attached at full throttle for an extended period of time as you can burn out the mosfet chips on the ESC,s (electronic speed controllers). It’s a good idea to open the shell and raise any motor wires that are contacting the chips as the smaller gauge wires on the 2312 motors get hot with extended use like switching out one battery after another with no cool down time in between flights. DJI assemblers had a habit of laying motor wires flat between the MOSFET Chips. Do some research and keep your quad flying cool. If you read this far you probable care about your investment. It only takes a couple of flights and you’ll be re attaching your camera. Always make sure to remove the battery before removing or attaching the wire harnesses and do not use any metallic item to seat the connectors as you can burn out the cameras main board if you forget to remove the battery. I’m a disabled hobbyist who loves the inner workings of things and I’m good at what I do. I will be posting 10 + more DJI quads and cameras in the very near future. You can ask me any questions you like about the DJI Phantom 2 vision and Phantom 2 vision + models. I, don’t know about the new Phantom 3’s and parts aren’t’ yet available but I see that people are already crashing them so more and more parts will be available. This item will ship out the same day the funds are cleared if before.5:00pm CDT.

Comments

Leave a Reply